

Copyright © 2026 Fluent Conveyors, LLC. All rights reserved.
The Fluent Conveyors logo is a registered trademark of Fluent Conveyors, LLC. Serial Number 97664258 Registered on Dec. 12, 2023

The best conveyors for recycling scrap metal are heavy-duty roller chain conveyors with steel belts that take the impact and abrasion of shredded fragments, castings, and mixed scrap at infeed and shredder feed, with flat idler conveyors presenting a thin, even layer to the magnets and eddy-current separators that recover metal downstream.
Fluent designs and manufactures conveyors and conveyor systems for scrap metal recycling lines, made in the USA and built to drop into your plant layout.
A scrap metal recycling operation processes shredded auto and industrial scrap, sheet and plate, turnings and chips, cans, wire, white goods, castings, and mixed grades, across ferrous and non-ferrous metals. Each stream arrives with its own weight, size, and abrasiveness, and most of it passes through several conveyors before and after shredding.
Fluent builds the conveyors that move scrap into, through, and out of the recycling line. That covers infeed off the yard or receiving area, the feed conveyors that meter scrap into shredders, shears, and balers, the discharge conveyors that carry shredded material clear, transport between magnets, eddy-current separators, and sorters, the picking conveyors that present material for a manual pass, and the stackers that build stockpiles by grade.
If your line moves scrap from the yard to a shredder, from a magnet to a separator, or from a sorter to a stockpile, contact us.

A scrap metal recycling plant is a sequence of equipment. Each conveyor is chosen for the material it carries and where it sits in the process.
Six factors set the specification:

Below, we map conveyor types to their place in a scrap metal recycling line, explain why feed presentation drives throughput and metal recovery, and detail the belt, pan, and drive choices that hold up through heavy, sharp, abrasive scrap.

Material moves from receiving and infeed, through shredding or shearing, into discharge, magnetic separation, eddy-current separation, and a picking pass, then to stockpiling and baler loading. Let's look at the conveyors a typical plant might utilize at each point.
The conveyor feeding the shredder sets the throughput ceiling, and the conveyors feeding the magnets and eddy-current separators set how much metal the line recovers and how clean each grade is.
Four feed variables have the greatest effect on throughput and recovery:
A speed sensor on the feed conveyor confirms the belt is holding the set speed under load, which keeps feed rate matched to the shredder and keeps separation consistent.
Heavy, sharp, abrasive scrap needs application-specific belts, pans, liners, and reinforcement. Fluent specs the carrying surface to the stream and stocks the conveyor belts for scrap metal recycling to match.
Routine inspection and maintenance catch these early. Learn what causes wear and tear on a conveyor belt.
Scrap metal recycling conveyors create specific hazards, including sharp edges that cut during cleaning and clearing, and fire from sparks, hot bearings, tramp material, and lithium-ion batteries in mixed loads. Guarding, emergency stops, and pull cords are standard along picking and transfer conveyors, and lockout/tagout access must be engineered for the frequent cleanout that fines, spillage, and jams require.
Every conveyor in a recycling operation should exceed the safety standards imposed by the relevant authority. See how to reduce conveyor hazards for the details.


Fluent designs and builds custom conveyors and conveyor systems for scrap metal recycling lines.
Contact us to talk through your line, or send the material type, target capacity, and run dimensions, and our engineering team will scope a system to fit your plant and the rest of your scrap metal recycling line.